Daiwa TANACOM 1000 Manuel d'utilisateur télécharger pdf (Page 17)

Should “Err” appear on the display, then use the MODE SET

BUTTON to re-enter the data.

6. Pull an additional 50m of line from the spool.

7. Press the RESET BUTTON for 2 seconds to show 100.0 on

the upper counter.

8. Wind up the 100m of line you pulled from the reel. This

completes the procedure.

Attention

1.Do not wind the end of the line onto the spool because it causes incorrect length

calculation. Move the power lever to OFF, and wind manually when nearing the end of

the line.

2.There are cases in which the length of the line will not be displayed if it exceeds 100m

when entered with this method.

Line data input (Backing line 2)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Pas de commentaire

Daiwa TANACOM 1000 Manuel d'utilisateur Page 17