Daiwa TANACOM 1000 Manuel d'utilisateur télécharger pdf (Page 15)

MAX

Attention

2.The motor can be overloaded when winding at very high tension for a long time (about 15

minutes). In this case, the motor will automatically stop. This does not occur while fishing

as water helps cool down the motor. If the motor stops, wind manually or move the

power lever momentarily back to OFF and then resume winding. Wind the line at high

speed (less tension).

6. As indicated by the lineʼs color coding, wind the line up until the

remaining line is 100m.

With the power lever moved forward, P2 changes into a tension

indicator. Keep line tension between 5 and 7 while winding.

7. Press RESET BUTTON for 2 seconds.

P2 blinks and the counter in the lower area shows 50. The

upper counter digits increase as line is wound.

8. Wind on another 50 m of line, keeping line tension at the

suggested level.

9. Press RESET BUTTON for 2 seconds.

The lower counter shows 100.

10. Wind the remaining 50m, keeping line tension at the

suggested level. Do not wind line all the way onto the spool.

11. Press RESET BUTTON for 2 seconds and 0.0 will appear.

This is the end of the procedure.

Attention

1.Do not wind the end of the line onto the spool because it causes incorrect length

calculation. Move the power lever to OFF, and wind manually when nearing the end of

the line.

Should “Err” appear on the display, then use the MODE SET

BUTTON to re-enter the data.

Line data input (With backing line)

1.Do not allow line to rub against the palming plate while winding as it could scratch the plate.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Pas de commentaire

Daiwa TANACOM 1000 Manuel d'utilisateur Page 15